
install your grad cap
1. Without applying pressure, place the hole over your cap button make sure the hole is wide enough. If the hole outlines the outer edges of your button, you are good to go.
If the hole is too small, use an x-acto knife to lengthen the pre-cut slits slightly.
2. Place hole over button. Apply pressure slowly, allowing the flaps to bend upward until the paper touches the base of the cap.
3. Use a something sturdy and flat (letter opener, nail file, screwdriver, etc.) to carefully tuck the flaps under the button.
Note: Be careful if using something pointy, as it may tear while tucking. One or two flaps may fall off during the process, but it will still hold.
4. To secure the corners so they don’t lift, or so the topper won’t rotate, fasten the corners with double sided tape, or with removable Glue Dots (Glue Dots are strong, but temporary and won't damage the hat or topper. Find them here: https://amzn.to/2PX0DOx